Cosmo COS-UMC30 Instrukcja i Przewodnik Użytkownika Pobierz pdf (Strona 3)

28"/33"

CENTER LINE

HOOD

MOUNTING

SCREWS

(in cabinet bottom)

CABINET FRONT

DUCTED INSTALLATION

Determine whether the hood will discharge vertically or

horizontally. For vertical or horizontal discharge, run ductwork

between the hood location and roof cap or wall cap.

A minimum 6” round duct must be used to maintain maximum

airow efciency.

Always use rigid type metal ducts only.

Whenever possible reduce the number of transitions and turns

in the ductwork. If a long duct run is required increase the duct

size from 6” to 7”.

If elbows or bends are required; install as far away from the

hood as possible.

Minimum mounting height between the range and the bottom

of the hood should be no less than 26”.

Maximum mounting height between the range and the bottom

of the hood should be no more than 34”

WARNING!

FIRE HAZARD

NEVER implement ductwork in a space between walls, crawl

spaces, attics or garages. All exhaust must be vented outside.

Use metal ductwork only. Fasten all connections with sheet

metal screws and certied silver tape or duct tape.

2. Use the following diagram for placement of ductwork and

electrical cutout in cabinet. For a non-ducted installation, DO

NOT cut a duct access hole.

DUCTED INSTALLATION (CONT)

The hood is designed for installation under a kitchen

cabinet:

WARNING

To reduce the risk of electrical shock, switch the power off at

the service panel. Lock or tag the service panel to prevent

power from being switched on.accidentally.

1. Remove the baffle lters from the unit.

2. Reinforce cabinet with 1” x 2” wood strips if additional

support is required.

26”~34” ABOVE

COOKING SURFACE

1 2 3 4 5 6 7 8 9

Komentarze do niniejszej Instrukcji

Brak uwag

Cosmo COS-UMC30 Instrukcja i Przewodnik Użytkownika Strona 3

Komentarze do niniejszej Instrukcji